Fireplace Gas valve
We recently turned our gas fireplace on and had an issue with the valve supplying gas. We ran some tests and determined that the valve was stuck in the closed position. The inside of the valve had failed therefore the gas was unable to be supplied into the fireplace area. This replacement on/off gas valve was available online for around $40 dollars so we purchased the valve and installed it ourselves. See below for our step by step procedure on safely removing and replacing a gas fireplace valve.
NOTE: It is highly recommended to have a licensed professional repair your gas fireplace valve. There is no room for error here as if you do not tighten the fittings properly a gas leak can occur and death or injury can result.
So, if you are experienced mechanically and have solid DIY know how, then proceed but with extreme caution.
Here is our old valve that failed to provide gas to our fireplace.
We FIRST TURNED OFF THE GAS OUTSIDE AND INSIDE and made sure it was safe to begin work.
We then carefully removed the artificial logs from our fireplace.
Once the logs were removed we needed to remove the log holder assembly.
The log holder assembly has been removed from our fireplace.
We then had to remove the sand material to be able to safely get the valve removed.
Finally we were able to get to the valve to replace it.
Disconnect the gas line and carefully remove the complete gas assembly.
We removed the sand and the complete gas assembly then began to carefully remove the valve.
We have the faulty gas valve removed and ready to install the new one.
We fully assembled our new gas valve before installing it into our fireplace.
We then safely and properly attached our new gas valve to the complete gas assembly.
NOTE: At this point run air from an air compressor through the
gas assembly while using a soapy water solution and check for leaks!
Apply the soapy water to the connection points while blowing air through the gas tubing.
If bubbles occur then you have a leak. Tighten all fittings until the bubbles stop.
Once you have verified you have NO LEAKS, then proceed.
We then placed the complete gas assembly into our fireplace and connected the gas line.
|
AKDY 28" Black Electric Firebox Fireplace Heater Insert W/Remote Azfl-EF05-28r Home (AKDY)
|
|
Rutland Fireplace Insert Insulation Fiberglass, 1-1/2-Inch by 10-Feet Home (Rutland)
|
|
Country Split Oak Vented Dual Burner Log Set for Natural Gas Fireplace, 24-Inch Home (Sure Heat Manufacturing Inc)
|
|
Dimplex DFI2309 Electric Fireplace Insert Home (Dimplex)
|
|
MEECO'S RED DEVIL 585 Glowing Embers, 12 Oz Home Improvement (MEECO MFG CO INC)
|
Can you help with Valor fireplace gas insert remote control?
There should be a set of metal cards attached inside the fireplace.
First you should read everything there.
I know you have to first light the pilot light.
And then there should be a wall switch.
The problem I have currently is that it won't stay lit when the artificial logs are there.
The Atlanta metropolitan area, officially (as designated by the US Census Bureau) known as the Atlanta-Sandy Springs-Marietta Metropolitan Statistical Area and unofficially known as metro Atlanta, is the most populous metro area in the U.S. state of Georgia and the ninth-largest metropolitan statistical area (MSA) in the United States. Its...
@Jennifer B.: Been wondering why my fireplace hasn't worked in a year and a half. Well. The gas company didn't turn on my gas 😑😐😐😐😐😐😐
@TheGPBRTeam thank you. It's got a wood burner and the other fireplace is gas but think I'll have it as a real fire..cosy!